Non-motoring > TRVs Miscellaneous
Thread Author: bathtub tom Replies: 22
View Flat 

New Thu 9 Dec 21 19:25 
 TRVs - bathtub tom
>> I had the bleed screw was on top of one of the pipes connecting the two panels. It was set >>inside a small dimple to stop it protruding.

No, these small dimples are on each panel.

>>Is the pump in the airing cupboard and does the CH pipework branch off the pump there?

Not found the pump yet, I guess it's contained within the boiler body. Definitely not in the airing cupboard, or the loft (as far as I can see). I can't see any 2 or 3-way valves. I'm hoping this old system will limp along for the colder months and I'll see about replacing it when it's warmer for a condenser boiler and put a small rad in the airing cupboard to replace the tank and keep SWMBO happy. But I'd like to find a way to stop the hot water being atboiler temperature.
Last edited by: bathtub tom on Thu 9 Dec 21 at 19:25
<< Prev | Next >>
Reply to this message | Report message
       
 Messages Author Date
 TRVs new bathtub tom 3 Dec 21 19:48
 TRVs new Fullchat 3 Dec 21 20:05
 TRVs new Terry 3 Dec 21 20:08
 TRVs new No FM2R 3 Dec 21 20:43
 TRVs new Kevin 3 Dec 21 21:35
 TRVs new Zero 3 Dec 21 21:57
 TRVs new Kevin 3 Dec 21 22:18
 TRVs new bathtub tom 3 Dec 21 21:38
 TRVs new Fullchat 3 Dec 21 22:29
 TRVs new bathtub tom 4 Dec 21 17:07
 TRVs new Zero 3 Dec 21 21:59
 TRVs new bathtub tom 9 Dec 21 17:13
 TRVs new Kevin 9 Dec 21 17:44
 TRVs new bathtub tom 9 Dec 21 19:25
 TRVs new Kevin 9 Dec 21 19:45
 TRVs new Zero 9 Dec 21 20:12
 TRVs new bathtub tom 9 Dec 21 22:40
 TRVs new Kevin 10 Dec 21 07:31
 TRVs new bathtub tom 10 Dec 21 08:54
 TRVs new henry k 9 Dec 21 20:49
 TRVs new bathtub tom 9 Dec 21 22:31
 TRVs new Terry 10 Dec 21 09:51
 TRVs new Kevin 10 Dec 21 10:32
Latest Forum Posts