Assuming my previous solution was not correct, in that you did not have a car with towbar available......
Position a a 'Workmate' directly above the cover with the legs akimbo the cover, Run 2 verical ropes up from the lifting eyes thro the jaws and then loop each of the ropea full 360 around bo the jaws and tie off. Slowly wind the work mate handles to widen the gap - ensuring that any skew of the cover is corrected by 'differential screwing'.
Just hope that d i ff e rential s c r e w i n g makes it thro the **** filter :)
I think that a genuine workmate would take the load, not sure my £10 chinese lookalikes would!
|