Hi All
I asked the same question on a dedicated forum, but im a little confused as I don’t think I can get a clear answer as I really don’t want to damage my car.
I want to get a trolley jack so I can take my wheels off and clean them properly however I’m getting conflicting advice from the site, and my friends.
Some people say that it will be fine to use the jacking points that you would use the scissor jack for as on the Vectra there are plastic blocks on the underside of the car for you to do this.
Some say not to, and use a strong part of the chassis, where the front wheel strut is (behind it not on the arm) however I cant really see where I would put the jack.
Whenever Ive gone to a quickfit type place, they just roll it under the car without looking - Im not going to do this.
Anyone got any Ideas
Mods: I could not decide which category to put this in, please move it to the right one if necessary. ok, I'll put it in Technical Matters
Thanks in Advance
Last edited by: VxFan on Fri 9 Jul 10 at 12:52
|