I had a look under the bonnet after a very faint smell of oil. I found what im assuming is a breather pipe ( comes out of what I assume is the fuel injection and goes into the rocker cover ) which was half hanging out and some oil had dribbled out onto the block, not much, just a little, enough to make it smell a bit.
I stuck the pipe back in, but its very loose and could easily wiggle out again on a bumpy road. My question is really, how loose should it be ( or not at all )?
Ill take a picture if clarification is needed on what the pipe looks like.
Thx :-)
|
consider it to be a flame trap with a one way valve in it?
clean it out with something like petrol but to be honest it should be a snug fit
probably elongated the hole as its been waddling out?
|
Looking at the picture, it looks a bit like those clips holding the two pipes together arent in the original position, maybe the tension has pulled the pipe out over time.
|